GMC Acadia Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Have a 2017 Acadia SLT-2 3.6 V6 AWD
My side detection quit. Thought i might be the module.... my part number in Vehicle was 23395451 RH, dealer had another superseded number, and made it seem that it didn't matter if it went left or right. So bought over internet 23395354 LH. (when i bought it don't know which side it was on).... installed the LH module but error message stayed....
sure might be the harness (or a failed sensor in the harness).

Couple of questions for the better wrenches in the group.
1) Would the LH work on the RH harness?
2) After installation of said module; do i need to reset error messages? if so how with out a code reader?
3) how would on test harness to see if failed.....
4) with the new number module (it dies not specify R or L side) is it different?
 

·
Registered
Joined
·
84 Posts
Did you program the new module to the car?


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
84 Posts
If you have GM credentials yes, otherwise not sure.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
Did you program the new module to the car?


Sent from my iPhone using Tapatalk
srry for delay in getting back to you; working with another GM dealer for programming and was told harness corroded; looking at new harness, then to get programming done... thanks for help.
 
1 - 6 of 6 Posts
Top