GMC Acadia Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
I need the AC compressor pinout at the fuse box. Id like to run a wire from the fuse down to the compressor plug.
I have been fighting small gremlins with my AC wires for some time now. I just installed a new radiator and decided to go ahead and install my new AC compressor pigtail since my wires had missing insulation and were taped up. After I installed the new pigtail on the harness side, it is now blowing the AC fuse (again). Im pretty sure its due to the bad wires in that cluster of wires that I have made repairs to for the oil pressure sensor. These wires are exposed to oil and heat, bad combination. Im at 292K miles and it still runs good. Next im doing the timing chains.

Any help would be awesome. Thanks
 

·
Super Moderator
Joined
·
19,534 Posts
There's a link in another thread to download a file containing the 2010 service manual - w/wiring diagrams, t/s procedures, etc. Information in that document should be similar to what you need. Lambda architecture didn't change much through the years.
 
1 - 4 of 4 Posts
Top